Configuration - AKO 52044 Mode D'emploi

7.- Configuration

Alarm configuration is carried out sending messages (SMS) to the telephone number installed in the alarm (SIM
Card).
-In all of the examples shown, the password printed on the alarm label is used by
default. If you have changed it, remember to replace it with the current password.
-The password is necessary only to add numbers to the "telephone list" or to change the password
itself. For all other configuration, it is necessary only for the telephone number sending the messages
to be registered on the "telephone list".
-We recommend that using the application "AKO-52044" for smartphones to carry out the
configuration. It is available at www.ako.com and in the Google Play Store and Apple
App Store.
WARNINGS:
-In the configuration, confirmation, and tracking messages, use commas (,) only to separate the
different parameters, never to define alert messages. The only purpose of the blank spaces is to define
alert messages.
-Messages must be ALWAYS be in upper-case.
-Pay special attention to your mobile telephone's spell check function. Check that the message is
correct before sending it.
-No accents, umlauts or special characters may be used.
Telephone list
Allows you to create a list of telephone numbers to which the alarm sends alert and confirmation messages (see pg. 22).
Only the telephone numbers on this list can make changes to the alarm configuration,
confirm alarms or act on the outputs.
Send "PHONELIST,<password>,<response time>,<number1#number2#number3#number4...#number10>
Maximum confirmation time in minutes; if after this time a confirmation message has not
<response time>
been received, the alert will be sent to the next telephone on the list.
Example: For a response time of 5 minutes, send:
After a few seconds, the alarm responds with the message*:
PHONELIST OK
*If you receive an error message, refer to page 26.
PHONELIST,1234,5,609111111
#609222222#609333333#609444444
#609555555#609666666#609777777
#609888888#609999999#609000000
20
5204H401 Ed.04
SEND