Prepare The Receiver Collar; To Insert And Remove The Batteries - Radio System Corporation Pet Safe ST-100 Manuel D'utilisation

STEP 2

Prepare the Receiver Collar

To Insert and Remove the Batteries

2A
2B
Batteries
(CR2032)
1. Remove the screws with a small Phillips screwdriver, applying
adequate pressure for the screwdriver head to fi t snugly into
the screw (2A).
2. Push the Battery Lid up according to the arrows stamped on the
Battery Lid (2A).
3. Slide the Battery Lid out.
4. Install two (2), 3-volt batteries positive (+) side up (2B). Slide the
Battery Lid into the Receiver Collar.
5. Reinstall the screws (2B). Do not over-tighten the screws.
The Receiver Collar is waterproof. When changing the batteries, be
sure to keep the area free of dirt and debris. Also, ensure the screws
are fl ush with the Battery Lid. Replacement batteries (3-volt, CR2032)
can be found at many retailers. Contact the Customer Care Centre or
visit our website at www.petsafe.net for a list of common retailers.
www.petsafe.net 13