GreenWorks Tools 3802507 Manuel D'utilisation page 5

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
trigger is released, the chuck stops turning. When the
brake is functioning properly, sparks will be visible through
the vent slots on the housing. This is normal and is the
action of the brake.
Wood Drilling
For maximum performance, use high speed steel bits for
wood drilling.
■ Select drilling mode.
■ Begin drilling at a very low speed to prevent the bit
from slipping off the starting point. Increase the speed
as the drill bit bites into the material.
■ When drilling through holes, place a block of wood
behind the workpiece to prevent ragged or splintered
edges on the back side of the hole.
Metal Drilling
For maximum performance, use high speed steel bits for
metal or steel drilling.
■ Select drilling mode.
■ Begin drilling at a very low speed to prevent the bit
from slipping off the starting point.
Maintain a speed and pressure which allows cutting
without overheating the bit. Applying too much
pressure will:
• Overheat the drill;
• Wear the bearings;
• Bend or burn bits; and
• Produce off-center or irregular-shaped holes.
■ When drilling large holes in metal, start with a small bit,
then finish with a larger bit. Also, lubricate the bit with
oil to improve drilling action and increase bit life.
Masonry Drilling
For maximum performance,
masonry impact bits when drilling holes in brick, tile,
concrete, etc.
■ Slide adjustment button on hammer drill left for
hammer mode.
■ Apply light pressure and medium speed for best
results in brick.
■ When drilling holes in tile, practice on a scrap piece
to determine the best speed and pressure. Begin
drilling at a very low speed to prevent the bit from
slipping off the starting point.
MAINTENANCE
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
English (Original Instructions)
use carbide-tipped
WARNING
General Maintenance
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and can be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which could result
in serious personal injury.
Tool Storage
Always remove battery pack from tool before storing the
tool.
Battery pack preparation for recycling
Do not attempt to destroy or disassemble battery
pack or remove any of its components. Lithium-ion
and nickel-cadmium batteries must be recycled or
disposed of properly. Also, never touch both terminals
with metal objects and/or body parts as short circuit
may result. Keep away from children. Failure to
comply with these warnings could result in fire and/or
serious injury.
DISPOSAL
The machine, rechargeable batteries,
accessories and packaging should be sorted
for environmentalfriendly recycling.
Do not dispose of power tools and batteries/rechargeable
batteries into household waste!
ENVIROMENTAL PRORENCTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
5
WARNING
WARNING