Kubota EC815-20L Manuel Du Propriétaire page 9

ASSEMBLY-Preparing the Vacuum for Assembly
1
1. Verify that the power cord is disconnected from the outlet.
2. Undo the latches.
3. Lift the power head off the dust drum.
4. Remove the contents of the tank.
5. Insert the wheel stem into the socket of the caddy as shown. Push
on the wheel until the ball on the wheel stem is inserted all the way
into the socket. Turn the dust drum upright.
a.Wet vacuum cleaning: Pull the supplied sponge filter over the
6.
filter basket.
b.Dry vacuum cleaning: Slip the paper dustbag onto the suction
port.
c.Dry vacuum cleaning: Pull the supplied non-woven bag over the
filter basket for dry vacuum cleaning.
7. Place the power head assembly on top of the dust drum. Ensure the
power head assembly completely covers the top of the dust drum so
leakage does not occur. To remove the power head assembly,
reverse these directions.
8. Pull down latches to lock.
9. Insert the larger end of the hose into the vacuum port. Turn the hose
connector.
10. Connect the tube into the floor brush/sofa brush and it is ready to use.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE WALL
OUTLET BEFORE REMOVING THE TANK COVER.
4 Gallon Wet & Dry Vacuum Cleaner ENGLISH
9