Maintenance; Cleaning The Inspection Window; Fuses; Troubleshooting Guide - Truma LR 3 Manuel D'utilisation

Maintenance

Cleaning the inspection window

Clean the inspection window with water (without
cleaning agent). Use a soft sponge, woollen cloth
or chamois leather. Never use sharp objects or solvents to
remove stains.

Fuses

Depending on the variant, a fuse (3.15 AT) is installed in the
supplied connector cable. Only replace the fuse with one of
the same type.

Troubleshooting guide

Fault
– No flame or glow.
– No sound.
– The front case with flame
effect does not react to
switching commands from
the remote control.
– The remote control's
function display does not
acknowledge any button
pressing.
– The front case with flame
effect does not work.
If these actions do not remedy the problem, please con-
tact Truma Service.
Cause / Remedy
– Increase the brightness.
– Turn up the volume.
– Point the remote control
at the IR receiver when
performing switching
commands.
– Check that the batteries in
the remote control are in
perfect condition.
– Check the supply line and
make sure that the plug is
inserted correctly.
– Check the fuse in the vehi-
cle's power supply / con-
nector cable.
– Check whether the supply
battery is in perfect condi-
tion and is fully charged.
– Perform a reset. To do this,
interrupt the power supply
for at least 20 seconds.

Disposal

The appliance must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-life Vehicle Regulation) must be observed.
In other countries, the relevant regulations must be observed.

Technical data

SELV power supply (Safety Extra Low Voltage)
12 V
Protection class
III
Power consumption
12 W
Quiescent current
< 1 mA
Weight
approx. 2.8 kg
Subject to technical changes.
EN 7