Using The Device - Thermor Cascade 2 Notice D'installation Et D'utilisation

1) Description of the control panel
1
2) Setting the CONFORT temperature
It is the temperature desired when the room is occupied.
a) Set the switch to
b) Align the toothed screw
rature is less than desired.
Wait a few hours for the temperature to stabilise.
If the temperature setting does not suit you, adjust it using the adjusting screw
by-step using the notches (one notch at a time).
The thermostat's cycle takes several minutes. It is possible that the heating indicator may not react
instantaneously, but instead only on the next thermostat cycle.
3) Standby (Hors Gel) Mode
It is the mode enabling to maintain a temperature of approximately 7°C in the room in case of pro-
longed absence from the house.
a) Leave switch on the Marche position.
b) Set the knob to
4) Turbo mode
It is the mode enabling to set the device into Forced Operation, ensuring prompt temperature
increase in the room over the time defined (maximum power for conventional models and fan acti-
vation point for models with ventilating fan).
a) Leave the switch
b) Select the time for the Turbo using the knob
c) Press the command
d) The TURBO mode can be interrupted manually before the end of the time set. In order to do this,
press the command
NB: For piloted devices, only the heating stop and frost setting instructions are prioritised when
TURBO mode is activated (the other instructions are inoperative).
U
SING THE DEVICE
2
7
6
5
to the ON position, the
with the marking
.
on the Marche position.
, the indicators
again.
Temperature setting knob with Hors Gel
position and ability to restrict the range.
Time adjustment knob TURBO
1/4h, 1/2h, 1h, 2h.
Power On indicator
3
TURBO indicator
4
TURBO control
Heating ON/OFF switch
Heating indicator
indicator lights.
: the indicator light
.
light.
and
18
illuminates if the tempe-
. Proceed step-