Chaffolink Installation; Important - CHAFFOTEAUX ChaffoLINK 3319221 Notice Technique D'installation Et D'entretien

5. ChaffoLink INSTALLATION

This chapter describes the installation procedure of ChaffoLink. We recommend to
start up the procedure making first the gateway connection with the thermoregula-
tion accessory and with the heating product. After that, it will be possible to connect
the gateway to the power supply and to fasten it to the wall through the wall plate.

Important:

The installation of Expert Control is possible only with Chaffoteaux products run-
ning the Bus protocol. If there is an existing thermostat connected to the heating
system replace as follows: Remove the existing room thermostat following the
procedure described it its installation manual, the 2 core cable has to be unplugged
from the TA1 connector on the boiler (Paragraph 5.1).
CAUTION!
The installation must be performed by qualified personnel. Before its assembly,
switch off the power supply of the boiler. The Bus cable is polarized: to avoid
any communication issue respect the polarity between all the products in the
heating system.
5.1 Possible installation architectures
With the intent to give several examples to lead the installation of ChaffoLink, in the
following paragraph are reported some major system diagrams that could be realized
through ChaffoLink and other accessories already in the Chaffoteaux products range.
With each example, is also specified which services can be activated.
The term "Remote Diagnostics" (RD) refers to the utility dedicated to Service Centers,
through which all the assistance features of ChaffoLink are enabled.
"Remote Control" (RC) refers instead to the service oriented to the end user, through
which he can use the ChaffoLink smartphone app or web portale to monitor and set its
Chaffoteaux products.
60
For further info and details on the installation diagrams shown below, please contact the
Chaffoteaux Technical Center of your Country.