EUFAB 21014 Manuel De L'opérateur page 5

• Do not pump gasoline, kerosene or other highly flammable liquids! EXPLOSION HAZARD!
• Do not pump water or gear oil: this may cause damage to the pump.
• When connecting the battery clips, keep correct polarity!
• Always switch the engine off when pumping.
• Always heat engine oil up before pumping!
• Never let the pump "running idle" When oil pumping is interrupted, switch the pump off immediately.
4. CAUTION
The oil pump is designed to run for approx. 15 minutes. After that, let the pump cool down. Do not let the oil suction pump
run empty for more than 30 sec.
5. OIL PUMP USE INSTRUCTIONS
1. Before replacing oil, heat the engine up until the temperature reaches approx. 40 - 60°C.
2. 2Switch off the engine!!
3. Remove the protection caps from the sockets. Insert the pumping hose (1) in the suction neck and insert the outlet hose
in the outlet neck of the pump. To make sure that the hoses do not let loose, fasten them using the clips supplied.
4. Insert the pumping well (1) into the oil-gauge hole down to the deepest point of the engine sump.
5. Put the outlet hose (2) into a suitable container. (You can look up the fill-up capacity in your car´s manual)
6. Now, connect the oil pump to the battery. KEEP CORRECT POLARITY!!! (black clip to the negative pole, red clip to the
positive pole)
7. Switch the oil pump on (5) and start pumping.
8. When pumping is finished, switch the pump off. Never let the pump "running idle"
9. Refill the engine with new oil according to the car manufacturer's instructions. Next, check the oil level using the oil
gauge.
CAUTION
After finishing the job, clean the pump and its accessories properly; keep it in a dustproof
place.
6. NOTES REGARDING ENVIRONMENTAL PROTECTION
Do not dispose of electrical devices with household waste. Electrical devices and electronic scrap must
be collected separately and disposed of in an environmentally responsible manner for recycling. Please
contact your community or city administration regarding disposal options for electrical and electronic
scrap. The materials are recyclable. You make an important contribution to protecting our environment by
recycling, material utilisation or other forms of reusing waste equipment.
7. CONTACT
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
5