Dexter Laundry T-30 Manuel De L'utilisateur page 39

ATTENTION. Lors des opérations d'entretien des commandes, étiqueter tous les fils avant de les déconnecter. Toute
erreur de câblage peut être une source de danger et de panne.
If any of the following symptoms occur on this dryer, check the suggested remedies listed below. If all probable
causes have been eliminated and the symptom still exists, contact your local Dexter agent for further
troubleshooting assistance. See contact information in Preventative Maintenance section. Parts & Service Manuals
from Dexter are also available for further troubleshooting assistance.
Symptom
Tumbler Does not turn
Tumbler Turns, but no
burner flame is present
Slow Drying
"Temp Sensor Short" or
"Temp Sensor Open" Error
Code displayed on control
"PCB Error" or "Comm
Error" code displayed on
control
8514-234-001 REV N page 39
Probable Cause
Control
Loading Door
Lint Compartment Door
Drive Belts
Gas shut-off valve
Ignition Module
Control
Lint Screen
Air flow Restrictions/
Make-up Air
Exhaust
Temperature Sensor
Control Error
Suggested Remedy
Check that Control Display shows time available for
drying. If not, deposit money as needed.
Check that Loading Door is completely closed
Check that Lint Compartment Door is completely closed.
Check drive belts for excessive wear. Replace as needed.
Make sure gas shut-off valve is in the open position
Follow the procedure for checking the ignition cycle
listed in Dryer Ignition section of this manual.
Check that proper Temperature setting is chosen.
Clean Lint Screen
Follow installation guidelines for static back pressure and
make-up air
Check exhaust for obstructions, follow installation
guidelines
Press programming button to clear Error Code. If Error
code persists, contact Dexter agent for assistance
Cycle power to dryer to clear Error Code. If Error Code
persists, contact Dexter Agent for Assistance