Programming Mode - Sick Pac50 Notice D'instruction

Operating Instructions

7.4 Programming mode

7.4.1 Setting the device parameters
To switch to programming mode, the
programming mode is inactive for a long period (> 15 seconds), the device automatically reverts back to
display mode. The measuring and switching functions continue to run (in the background) while the device is
in programming mode.
Selecting:
The parameter/menu item to be set should be selected first using the
•
in display area B: e.g. "SET" is helpful in this regard.
To select the parameter/menu item to be set, press the
•
Making settings:
The parameter value to be set is displayed in display area A. Display areas C1/2 and E1/2 display the
•
existing parameter value settings.
The parameter is set using the
•
The setting becomes active the moment a selected parameter value is confirmed by pressing the
•
pushbutton, even if the pressure switch is still in programming mode.
6 6 O p e r a t i n g I n s t r u c t i o n s | S I C K
7 Operation and parameter settings
pushbutton must be pressed for longer than 2 seconds. If the
and pushbuttons and then confirmed with the
and pushbuttons. The note
pushbutton in the middle.
8017612/YSZ4/2016-02-09 | PAC50
PAC50
pushbutton.
Subject to change without notice