Starting And Stopping - Husqvarna WT 15 Mode D'emploi

External power supply
The water tank can be connected to an external power
source via a 12 to 24 V socket.
DC IN 12 - 24V
> 2,5 A
The connected AC/DC transformer must comply with the
following demands:
• Outgoing voltage: DC 15-20 V.
• Amperage: Min 2500 mA.
• Socket: EIAJ RC-5320.
When the water tank is connected to an external power
source, the battery is not used.
The battery does not charge when an external power source
is connected. Use the supplied battery charger to charge the
battery.
Storage
Store the equipment in a lockable area so that it is out of
reach of children and unauthorized persons.
Store the battery in a dry place at normal room temperature.
Do not expose it to direct sunlight, strong heat or moisture.

Starting and stopping

Before starting
CAUTION!
This machine is used in combination with other
products. Please read the manual provided with the
products carefully and make sure you understand the
instructions before using the machine.
NOTICE!
The water tank is only intended to be filled with water.
Do not immerse the water tank in water.
R297123
OPERATING
• Fill the tank with water.
Starting
The water tank can be run in two settings with various water
pressures/water flows.
• Position 1 provides a water pressure of 0.6 bar (8.7 psi)
and a water flow of 0-3 l/min (0-0.8 gal/min).
• Position 2 provides a water pressure of 1.1 bar (14.5 psi)
and a water flow of 3-5 l/min (0.8-1.3 gal/min)
Position 1
• Press in the button and release.
Position 2
• Keep the button pressed in until the diode turns green.
H O
2
English - 5