Varde In-Line 47 Instructions De Montage page 9

Preparation |
1 Brickwork
Before fi tting your fi replace insert, make sure that the fi replace is
ready and in good condition.
| Remove any protrusions, or brick up.
| Examine the bottom of the fi replace. The foundation must be level
and stable, and must not be cracked or porous. Cast a new founda-
tion if necessary.
2 Access hatch
20-30 cm
It is important that the inside of the chimney and pipes can be
cleaned, so it is necessary to fi t an access hatch. The access hatch is
fi tted 20-30 cm up in the chimney. The location of the access hatch
can be a major help when you later install the fl exible tubing.
IMPORTANT! Other regulations for the installation of access hatches
must always be observed.
16
DANSK | ENGLISH
3 Flexible tubing
To connect the fi replace insert to the chimney, you must fi rst install the
fl exible tubing in the chimney.
| Pull the tubing 20-30 cm up into the chimney from the fi replace, until
the access hatch is reached.
| Note the fl ow arrow indicating the direction of the smoke through the tubing.
| Apply insulation batts to insulate the tubing. Leave the top 2-3 cm
uncovered to facilitate the subsequent walling-in of the tubing (see point 8).
4 Flue
Once the tubing is secured in the chimney, the accompanying 45˚ fl ue
should be attached to the other end of the tubing.
| Fit the fl ue to the tubing, and fasten with a jubilee clip or the like.
| DEUTSCH | FRANÇAIS
17