Turbo Brush - Zelmer ODYSSEY Mode D'emploi

End of operation cleaning and
maintenance
1 Switch off the vacuum cleaner by pressing the "on/off"
button (1).
2 Unplug the appliance.
3 Wind the cord by pressing the cord rewind button (3).
While doing this hold the cord to make sure it is not tangled
and the plug does not hit the vacuum cleaner housing.
4 Disconnect the suction tube from the suction nozzle or
brush.
5 Disconnect the suction tube from the hose. In order
to remove the telescopic tube from the hose handle,
simultaneously press the lock A and pull the tube in the
direction indicated by the arrow.
6 Pull the end of the hose out of the inlet opening of the
vacuum cleaner.
7 The vacuum cleaner may be stored vertically or
horizontally. In order to do so, insert the fastening hook of
the combination brush to the combination brush fastener.
The hose may be attached to the vacuum cleaner, however
you have to make sure that it is not excessively bent during
storing.
8 If necessary wipe the housing and the dust bag container
with a damp cloth (it may be soaked with dishwashing liquid)
and dry it or wipe until dry.
Do not use abrasive detergents or solvents.
Examples of problems while operating the
vacuum cleaner
PROBLEM
A characteristic "fl uttering"
of the vacuum cleaner is
heard which indicates the
opening of the safety
valve.
The dust bag is damaged. Remove the dust bag and the fi lters.
The suction power of the
vacuum cleaner is weak.
The electrical installation
fuse went out.
The vacuum cleaner does
not operate; the housing or
the cord is damaged.
16
ACTION
• The dust bag may be full – replace
the dust bag.
• Replace the dust bag even if it is
not full yet. In unfavorable conditions,
fi ne dust might have clogged the
pores on the surface of the dust bag.
• The suction tube, the hose or the
attachment is blocked – remove the
cause of the clogging.
Replace the dust bag and the fi lters,
check the suction tube, the hose and
the nozzle - remove the cause of the
clogging.
Check if other appliances are not
plugged to the same electrical circuit
as the vacuum cleaner. If the fuse
goes out repeatedly, return the vacuum
cleaner to a service point.
Return the vacuum cleaner to
a service point.
F
G
1
4
5

TURBO BRUSH

A
B
3
6
2
4
450-020_v01