habitat et jardin Monaco Mode D'emploi page 44

A Maintaining water
1. Clean your filter cartridge at least once a time after it worked continuously for 72- 120 hours. The filter
cartridge should be replaced at least once a month depending on use.
2. Change water every few days or use appropriate pool chemicals. All spas require the use of pool chemicals.
Please consult your local pool supply retailer for more information about chemical maintenance. Pay close
attention to the chemical manufacturer's instructions. Spa damage resulting from misuse of chemicals and
mismanagement of spa water is not covered by the warranty.
c. Water balance; we recommend maintain your water PH between 7.2 and 7.8, total alkalinity between 80
and 120ppm and free chlorine between 3 to 5ppm.
Purchase a test kit to test your water chemistry before each use of the spa, no less than once per week.
Low PH will damage to the spa and pump. Damaged resulting from chemical imbalance is not covered by
the warranty.
d. Water sanitation is the responsibility of the spa owner, achieved through the regular and periodic (daily, if
necessary) addition of an approved sanitizer. The sanitizer will chemically control bacteria and viruses
present in the fill water or introduced during use of the spa.
B Cleaning the filter cartridge
1. Make sure to unplug the power pack from the electrical receptacle before the following actions.
2. Unscrew the filter cartridge by turning counterclockwise.
3. Remove the filter cartridge cover.
MAINTAINING
44
2019
2020-2021