Important - habitat et jardin Monaco Mode D'emploi

Height:
Number of air jets:
Nominal power :
Heating device:
Jet :
Cord length Power supply:
Filtre :
Cover Lid:

IMPORTANT:

Because of the combined weight of the spa, water, and users, it is extremely important that
the base where the spa is installed is smooth, flat, level and capable of uniformly supporting
this weight for the entire time the spa is installed. If the spa is placed on a surface, which
does not meet these requirements, any damage caused by improper support will void the
warranty. It is the responsibility of the spa owner to assure the integrity of the site at all times.
a) Indoors installation:
Be aware of special requirements if you install the spa indoors.
1. The floor must be able to withstand the capacity of the spa. The floor should be a non-slip,
level surface.
2. Proper drainage is essential for indoor spa installation. When building a new room for the
spa it is recommended that a floor drain be installed.
3. Humidity is a natural side effect of spa installation. Determine the effects of airborne
moisture on exposed wood, paper, etc. in the proposed location. To minimize these
effects it is best to provide plenty of ventilation to the selected area. An architect can help
determine if more ventilation is needed.
0.65 m/25.6"
130 X φ 3 mm
220-240V~,50Hz
1800W/1.63HP
600W/0.81HP
5.0M
12V CC, 50Hz 30W, 1880L/420gallon/H
PVC laminated polyester with aluminum foil
0.65 m/25.6"
130 X φ 3 mm
220-240V~,50Hz
1800W/1.63HP
600W/0.81HP
5.0M
12V CC, 50Hz 30W, 1880L/420gallon/H
PVC laminated polyester with aluminum foil
36
2019
2020-2021