Tool Safety - General International BG6001 Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

13. NEVER STAND ON TOOL
Serious injury could occur if the tool is tipped or if the abrasive wheel is
unintentionally contacted.
14. WHEN REMOVING SHORT WORKPIECES,
or cleaning up around the table, be sure that the switch is in the OFF
position and that the wheel has come to a complete stop.
15. KEEP HANDS WELL AWAY FROM CUTTING SURFACES
and all moving parts. Do not clear chips and sawdust away with hands.
Use a brush.
16. WHENEVER POSSIBLE USE A DUST COLLECTOR
with shaving hood to minimize health hazards.
17. SECURE WORK.
Use clamps or a vise to hold the work. It's safer than using your hands
and it frees both hands to operate the tool.
18. DISCONNNECT THE PLUG FROM POWER
before making any adjustments. Changing attachments or accessories
can be dangerous if the tool could accidentally start.

TOOL SAFETY

1. MAKE SURE ALL CUTTING TOOLS
are moving at operation speed before feeding.
2. DO NOT FEED THE MATERIAL TOO QUICKLY.
The cutting tool will perform better and be safer working at the rate for
which it was designed.
3. NEVER LEAVE THE MACHINE WITH THE POWER ON.
4. DO NOT FORCE THE MACHINE.
It will do the job better and be safer at a rate for which it was designed.
Don't force a small tool or attachment to do the work of a larger
industrial tool. Don't use a tool for a purpose for which it was not
intended.
5. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for better and safer performance. Follow
instructions for lubricating and safe performance. Follow instructions for
lubricating and changing accessories. Keep handles dry, clean and free
from oil and grease.
6. DO NOT USE THE TOOL
if it cannot be switched on or off. Have your tool repaired before using
it.
7. CHECK FOR DAMAGED PARTS.
Before using this tool, any part that is damaged should be carefully
checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mountings, and other conditions that
may affect its operation. Inspect screws and tighten any ones that are
loose. Any part that is damaged should be properly repaired or replaced
by an authorized service center unless otherwise indicated elsewhere
in the instruction manual. Have defective switches replaced by an
authorized service center. Don't use the tool if switch does not turn it on
and off properly.
8. USE ONLY RECOMMENDED ACCESSORIES.
Use of accessories NOT recommended by General International may
result in a risk of injury.
SAFETY PRECAUTIONS FOR
BENCH GRINDERS
Because each shop situation is unique, no list of safety guidelines can
ever be complete. The most important safety feature in any shop is the
knowledge and good judgement of the user. Use common sense and
always keep safety considerations, as they apply to your individual shop
situation first and foremost in mind. If you have any doubts about the
safety of an operation you are about to perform: STOP! Do not perform the
operation until you have validated from qualified individuals if the operation
is safe to perform and what is the safest method to perform it.
170313
5

Publicité

Table des Matières
loading

Table des Matières