General Maintenance - General International BG6001 Manuel D'installation Et D'utilisation

4. Remove the locking nut (n, fig 10), outer flange (o, fig 10) and the wheel
(C&H, fig 10).
NOTE:
„ The spindle (s, fig 10) on the left-hand side of the bench grinder has a
left-hand thread. The nut is unscrewed in a clockwise direction.
„ The spindle on the right-hand side of the bench grinder has a right-
hand thread. The nut is unscrewed in an counter-clockwise direction.
5. Carefully check the replacement wheel for damage, since its history
before purchase is obscure.
6. Fit the replacement wheel and outer flange on the spindle.
7. Ensure the wheel is a slide fit (not loose) on the spindle.
8. Replace the grinding wheel nut and tighten.
NOTE:
The spindle (s, fig 10) on the left-hand side of the bench grinder has a
left-hand thread. The nut is tightened in a counter-clockwise direction.
The spindle on the right-hand side of the bench grinder has a right-hand
thread. The nut is tightened in a clockwise direction.
9. Replace the cover on the wheel guard (A, fig 10).
10. Re-insert the 3 bolts, washers, lock washers,nuts, and tighten wheel
guard cover in place.
11. Re-adjust the tool rest, spark deflector and eyeshield.
12. Hand-rotate the grinding wheel to check its free movement and proper
adjustments.
13. Put on eye protection, plug in the bench grinder, stand to one side
and run the grinder at full speed for several minutes. Chances are new
wheels that have damage will fail at this stage.

GENERAL MAINTENANCE

● Blow out any dust that may accumulate inside the motor and guard
covers from time to time
● All bearings are sealed and permanently lubricated. No further
lubrication is needed.
CARE OF GRINDING WHEELS
In normal use, grinding wheels become cracked, grooved and rounded
at the edges, chipped out of true or loaded with foreign materials.
Cracked wheels should be replaced IMMEDIATELY, while any of the
other conditions can be remedied with a dressing tool (available at most
hardware stores). New wheels sometimes require dressing to make them
round.
NOTE: In case of an electrical fault always turn your power tool OFF
and disconnect from the mains electric supply before attempting to
diagnose and resolve the problem.
● An authorized repair center should do any repairs, modification, or
maintenance that involve disassembling the saw.
● Any damage to the tool should be corrected at an authorized repair
center. Contact General International concerning repairs.
WARNING! Never use flammable or combustible solvents around tools.
WARNING! To reduce the risk of injury, electric shock and damage to
the tool, never immerse your tool in liquid or allow liquid to flow inside the
tool.
n
A
170313
13