Power Source Connection - General International BG6001 Manuel D'installation Et D'utilisation

OPERATION

POWER SOURCE CONNECTION

POWER REQUIREMENTS
This tool is designed to operate on a properly grounded 120 volt, 60 Hz,
single phase alternating current (AC) power source fused with a 15 amp
time delayed circuit breaker. It is recommended that a qualified electrician
verify the ACTUAL VOLTAGE at the receptacle into which the tool will be
plugged and confirm that the receptacle is properly grounded. The use of
the proper circuit size can eliminate nuisance circuit breaker tripping when
using your tool.
CAUTION: DO NOT OPERATE THIS TOOL if the ACTUAL power
source voltage is less than 105 volts AC or greater than 132 volts
AC. Contact a qualified technician if this problem exists. Improper
performance, and/or, damage to the tool will result if operated on
inadequate, or excessive power.
CONNECT TO POWER SOURCE
Consult a qualified electrician for proper installation of receptacle at the
source of power. This tool must be grounded while in use to protect the
operator from electrical shock. If you are not sure if your outlet is properly
grounded, have it checked by a qualified electrician. Make sure the tool is
turned OFF when connecting the power cord to a properly grounded 120
Volts, 60 Hz, single phase, 15 amp power source.
WARNING! Risk of injury due to accidental starting. Do not use in an
area where children may be present.
WARNING! Prior to using the grinder, check that the eye shields, spark
deflectors, and tool rests are fitted and correctly adjusted and that you
are wearing safety gear including eye, hearing and breathing protection.
1. Hand turn the wheels to ensure they do not touch the guards, eye
shields, spark deflectors or tool rests and run freely.
2. To start grinder: push the right hand side of the switch. To turn the
grinder off, push the left hand side of the switch. The "ON" and "OFF"
positions are stamped on the switch plate.
3. If the grinder fails to start right away, switch it OFF, disconnect the power
cord and check voltage at power source.
4. Stand to one side, turn the switch on and allow the motor to reach full
speed.
WARNING! To reduce the risk of injury, no adjustments to tool rests,
spark shields or other components should be made while the grinder
wheels are turning.
5. Support the workpiece on the tool rest as close as possible to the wheel
face and gradually feed the workpiece onto the wheel. Use vise girip
pliers to hold small workpieces.
NOTE: Traverse the workpiece across the full width of the wheel to
prolong the wheel's flat surface.
170313
11