KS Tools 550.1500 Notice D'utilisation page 5

Introduction
Dear customer!
Thank you for buying one of our products. You can find all the information you need in these operating instructions.
Please read the instructions completely with care and observe the advice given. The operating instructions are part of
the Digital ignition timing gun (stroboscope) with LED display and should be kept intact. The manufacturer is not liable
for personal injuries and material damages which result from improper use.
1. Provisions for use
The manufacturer shall not be held liable for personal and/or material damage which can be traced back to unintended
use of the tool.
!
Pay heed to the vehicle manufacturer's specifications!
• For checking and setting the ignition timing on petrol engines
• For 12 volt systems with 2, 3, 4, 5, 6 and 8 cylinder engines
• For all established vehicles with high tension conducting ignition leads
• Particularly for engines with no angle markings on the belt pulley
• Can be used on 4 stroke, 2 stroke and dual spark ignition systems
2. Technical data
• Extra bright Xenon light flashes due to special lens
• Self-supply power through crocodile clips
• Additional crocodile clips (green) and inductive clamp for measuring rpm, dwell angle and voltage test
• Perfect ignition setting from 0 - 60°
• Dwell angle test from 0 - 99.9% with conversion table
• Engine speed meter from 200 - 9999 rpm
• Voltage drop test
• Voltmeter
• Control dial on the side of the housing for setting the flash delay
• Mode can be selected via a push-button on the back of the housing
3. Components
• Ignition timing pistol
• Cable set
4. Safety and usage instructions
Tools may in principle only be used for the purpose intended, under the conditions envisaged and within the limitations
as to their use.