Black & Decker GTC1843L Mode D'emploi page 6

ENGLISH
♦ Always ensure that all guards are fitted when using the
tool. Never attempt to use an incomplete tool or a tool
with unauthorised modifications.
♦ Never allow children to use the tool.
♦ Be aware of falling debris when cutting the higher slides
of a hedge.
♦ Always hold the tool with both hands and by the handles
provided.
Safety of others
♦ This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning the use of the appliance by a person
responsible for the their safety.
♦ Children should be supervised to ensure that they do not
play with the appliance.
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by EN
60745 and may be used for comparing one tool with another.
The declared vibration emission value may also be used in a
preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Warning symbols
The following warning symbols are shown on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Do not expose the tool to rain or high humidity.
Always wear non-slip safety footwear.
Warning! Do not touch the chain at the chip
ejection point.
6
(Original instructions)
Always wear head and eye protection.
To ensure continued safe operation, check the
chain tension as described in this manual after
every 10 minutes of use, and adjust back to a
clearance of 3 mm as required.
Beware of falling objects. Keep bystanders away.
Electrocution hazard. Keep at least 10 m away
from overhead lines.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
♦ Injuries caused by touching any rotating/moving parts.
♦ Injuries caused when changing any parts, blades or
accessories.
♦ Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods make sure you take regular
breaks.
♦ Impairment of hearing.
♦ Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF).
Additional safety instructions for batteries and chargers
Batteries
♦ Never attempt to open for any reason.
♦ Do not expose the battery to water.
♦ Do not expose the battery to heat.
♦ Do not store in locations where the temperature may
exceed 40°C.
♦ Charge only at ambient temperatures between 10°C and
40°C.
♦ Charge only using the charger provided with the
appliance/tool. Using the wrong charger could result in an
electric shock or overheating of the battery.
♦ When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
♦ Do not damage/deform the battery pack either by
puncture or impact, as this may create a risk of injury
and fire.