Alarm Setting - TFA 60.2504 Mode D'emploi

TFA_No. 60.2504 Anleitung 10.07.2009
Radio controlled alarm with monthly calendar
• During night-time, the atmospheric disturbances are usually less severe and recep-
tion is possible in most cases. A single daily reception is adequate to keep the accu-
racy deviation below 1 second.
• After the reception of the radio controlled time you can set the alarm time (see

4.3 Alarm setting).

4. How to operate
4.1 Manual setting of clock, time zone and calendar
• Hold MODE/SET button in normal mode. A short beep will sound. The hour digit is
flashing. Press +/12/24 or - button to adjust hours.
• Using MODE/SET button you can switch to setting minutes, seconds, year, month,
day and time zone (+12/-12) and adjust with +/12/24 or - button.
• The time zone (0 flashes in the display) is used for the countries where the DCF sig-
nal can be received but the time zone is different from the DCF time.
• The calendar week will be calculated automatically after setting date in normal
mode.
• Holding +/12/24 or - button, you will enter fast mode.
• Confirm with MODE/SET button.
• The instrument will quit automatically the setting mode, if there is no button used
within 30 seconds.
4.2 Alarm setting
• Press MODE/SET button.
• AL appears on the display.
• Hold MODE/SET button.
• The hour digit is flashing and
• Press +/12/24 or - button to adjust hours and minutes.
• Holding +/12/24 or - buttons, you will enter fast mode.
• Confirm with MODE/SET button.
• The alarm is activated.
• Once the alarm starts to ring,
• Press any button to stop the alarm.
• You can activate the snooze function by pressing the SNOOZE/LIGHT button.
• is flashing and the alarm will be interrupted for 5 minutes.
• To turn off the alarm function, press AL ON/OFF button.
12
14:11 Uhr Seite 7
appears on the display.
flashes.
Radio controlled alarm with monthly calendar
4.3 Event entry
• Press MODE/SET button twice.
• appears on the display.
• You can set up to 8 events.
• Hold MODE/SET button.
• The number in the bracket flashes.
• Press +/12/24 or - button to set the numbers (1-8).
• Press MODE/SET button to make the desired settings. The setting sequence is
shown as follows: month and day. Adjust with +/12/24 or - button.
• Confirm with MODE/SET button.
• The event day is framed and the bracket flashes.
• On the event day flashes in the display.
• Press HOME button to return to the actual month.
• For each new event start from the beginning.
4.4 Calendar
• Using or button you can switch to each single month.
• Press HOME button to return to the actual month.
5. Backlight
• Press SNOOZE/LIGHT button. The backlight will light for 5 seconds.
6. 12 and 24 hours system indication
• Press +/ 12/24 button in normal mode to choose 12 HR or 24 HR system.
• In 12 HR system AM or PM appears on the display.
7. RESET button
• If the unit does not work properly use a pin to press the RESET button.
8. Positioning and fixating
• With the foldable leg the instrument can be placed onto any flat surface or wall
mounted at the desired location by the hanging hole at the back of the unit.
13