Bosch Uneo Notice Originale page 11

OBJ_BUCH-1695-003.book Page 11 Thursday, March 6, 2014 1:07 PM
 When switching on with a blocked drilling tool, high
torque reaction can occur.
 Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
 Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and
lead to loss of control over the power tool.
 To save energy, only switch the power tool on when using
it.
 Avoid unintentional switching on. Ensure the On/Off
switch is in the off position before inserting battery
pack. Carrying the power tool with your finger on the
On/Off switch or inserting the battery pack into power
tools that have the switch on invites accidents.
 Do not open the battery. Danger of short-circuiting.
Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
 In case of damage and improper use of the battery, va-
pours may be emitted. Ventilate the area and seek
medical help in case of complaints. The vapours can irri-
tate the respiratory system.
 Use the battery only in conjunction with your Bosch
power tool. This measure alone protects the battery
against dangerous overload.
 The battery can be damaged by pointed objects such as
nails or screwdrivers or by force applied externally. An
internal short circuit can occur and the battery can burn,
smoke, explode or overheat.
 The battery is supplied partially charged. To ensure full ca-
pacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first
time.
 Read the operating instructions of the battery charger.
 Check the tight seating of the battery. Two locking lev-
els are possible.
 The battery charge-control indicator indicates the charge
condition of the battery for a few seconds when the On/Off
switch is pressed half or fully through. It consists of a
three-colour illuminating LED.
LED
Continuous lighting, green
Continuous lighting, orange
Continuous lighting, red
Flashing light, red
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Bosch Power Tools
Symbol
Capacity
≥ 66 %
> 33 % —66 %
> 11 % —33 %
≤ 11 %
English | 11
Meaning
Uneo: Cordless Rotary Hammer
Grey-marked area: Handle
(insulated gripping surface)
Article number
Read all safety warnings and all
instructions
Before any work on the machine itself,
remove the battery from the power
tool.
Wear protective gloves
Always wear ear protection
Wear safety glasses/goggles
Movement direction
Reaction direction
Next step of action
Prohibited action
Screwdriving
Drilling without impact
Hammer Drilling
Switching On
Switching Off
Low speed/impact rate
2 609 007 768 | (6.3.14)