Technical Description; Function Description; General Information On The Electrical Connections - Dometic PERFECTVIEW CAM 30C Instructions De Montage

PerfectView
6

Technical description

6.1

Function description

The camera, which is encased in aluminium housing, transmits image and sound to a monitor via a
cable. The built-in infrared LEDs improve night vision.
The camera consists of the following elements:
No. in
fig. 4, page 3
1
2
3
4
5
7

General information on the electrical connections

7.1 Laying cables
A
NOTICE!
The cables must not be exposed for long periods to solvents such as benzine, as the
solvents can damage the cable.
I
NOTE
• As far as possible, use original openings or alternative openings for the connecting
cable duct, e.g. the panelling edges, ventilation grilles or blank panels. If no open-
ings are available, you must drill holes for the cables. Check beforehand that there
is sufficient space on the other side for the drill head to come out.
• Cables and connections which are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
Please observe the following instructions:
• Wherever possible, lay cables inside the vehicle, as they are better protected there than outside
the vehicle.
If you do need to lay a cable outside the vehicle, ensure that it is well secured (use additional
cable ties, insulating tape etc.).
• To prevent damage to the cables, when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heater etc.).
Use corrugated piping or other protective materials to protect against mechanical wear.
EN
Description
Infrared LEDs
Microphone (only CAM30C)
Sleeve
6-pin connection cable
LDR sensor
Technical description
9