Audio Playback; Hands-Free Function - THOMSON WHP6316BT Mode D'emploi

Bluetooth connection to television
• Make sure that your television is compatible with
Bluetooth headphones.
• Check whether you must carry out the pairing
procedure using the Sound/Audio menu or using the
Connection menu. A connection to other accessories,
such as keyboards, is thus prevented.
• For more information, please refer to your television's
operating instructions.
• The headphones and the terminal device should be no
further than one metre apart. The shorter the distance,
the better.
• Make sure that the headphones are charged.
• Press and hold the power button for approximately 3
seconds to turn on the headphones („Power on", head-
phones flash blue). Press and hold the power button
for approximately 6 seconds to switch to pairing mode
(„removal successful", headphones flash blue/red). The
headphones are searching for a Bluetooth connection.
• Open the Bluetooth settings on your terminal device and
wait until "WHP6316BT" is shown in the list.
• Select "WHP6316BT" and wait until the headphones
are listed as connected in the Bluetooth settings on your
terminal device (connected).
• You can now use the headphones.
Note – Bluetooth password
Some terminal devices require a password in order to
connect to another Bluetooth device.
• If your terminal device requests a password for
connection to the headset, enter 0000.
7.2 Automatic Bluetooth connection (after success-
ful pairing)
• Make sure that the headphones are on.
• Press the Multifunction button to automatically connect
the headphones to your terminal device.
• You can now use the headphones.

7.3 Audio playback

Note
• Note that the functions described are only possible
with an active Bluetooth connection.
• Your terminal device must also support the individual
functions (in particular, it must support Bluetooth
profiles).
• For more information, please refer to the operating
instructions of your terminal device.
• The functions can still be controlled directly via the
terminal device.
• Set the volume on your terminal device to a low level.
• Start audio playback on the connected terminal device.
• Press the Multifunction button to switch between Play
and Pause.
• Press the arrow buttons to go to the next or previous track.
• Gently press the volume control from the middle position
upwards to increase the volume and downwards to
reduce the volume.
Note
The headphones will automatically switch off after about
25 seconds of inactivity (only when controlled using the
headphone buttons, for example, Pause).

7.4 Hands-free function

You can use the headphones as a hands-free set for your
smartphone if your terminal device supports it.
Press the Multifunction button once to answer an incoming
call. Press the Multifunction button again to end the call.
Note
Whenever you want to charge the headphones, please
switch them off first by holding the Power button
for about 3 seconds. For a complete restart, please
disconnect the charging station from the mains supply.
8. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents.
9. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
3