GreenWorks CS24B00 Manuel D'utilisation page 13

OPERATION
OPERATING THE SANDER
Fig.6
• Secure the workpiece to prevent it from moving under the sander.
• Place the sander on the workpiece so that all of the sanding sheet surface is in contact with the
workpiece.
• Turn on the sander and move it slowly over the workpiece. Make successive passes in parallel
lines, circles, or crosswise movements.
• Turn off the sander and wait until it comes to a complete stop before removing it from the
workpiece.
W A R N I N G
Unsecured workpieces could be thrown towards the operator, causing injury.
W A R N I N G
Keep your head away from the sander and the sanding area. Your hair could be drawn into the sander
causing serious injury.
W A R N I N G
To avoid damaging the motor from overheating, be careful not to let your hand cover the air vents.
Do not force. The weight of the unit supplies adequate pressure, so let the sanding sheet and
sander do the work. Applying additional pressure slows the motor, rapidly wears the sanding sheet
and greatly reduces sander speed. Excessive pressure will overload the motor, causing possible
damage from motor overheating, and can result in inferior work. Any finish or resin on wood may
soften from the frictional heat. Do not allow sanding on one spot too long, as the sander's rapid
action may remove too much material, making the surface uneven.
Extended periods of sanding may tend to overheat the motor. If this occurs, turn the sander off and
wait until the sanding sheet comes to a complete stop, then remove it from workpiece. Remove your
hand from the vent area, remove the sanding sheet, then with your hand removed from vent area,
turn the sander on and run it free without a load to cool the motor.
For detail sanding such as corners and crevices, use the tip of the sanding pad with small back and
forth motions.
12