Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
TO INSTALL/REMOVE BATTERY PACK
Fig.3
Battery pack
Battery pack
To install:
• Insert the battery pack.
• Make sure the latches on each side of the battery pack snap in place and that battery pack is
secured in the product before beginning operation.
To remove:
• Depress the latches on each side of the battery pack.
W A R N I N G
Always remove battery pack from your tool when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause
serious personal injury.
W A R N I N G
Battery products are always in operating condition. Therefore, the switch should always be locked
when not in use or carrying at your side.
TURNING THE SANDER ON/OFF
Fig.4
ON
OFF
• Install the battery pack.
• To turn the sander ON or OFF: push the ON/OFF switch in the direction shown.
SANDPAPER SELECTION
Selecting the correct size grit and type sandpaper is an extremely important step in achieving a high
quality sanded finish. Aluminum oxide, silicon carbide, and other synthetic abrasives are best for
10
Publicité
Chapitres
Table des Matières
