Use And Operation - Klarstein ICE VOLCANO 2G Mode D'emploi

EN
20

USE AND OPERATION

Before first Use
• Remove the exterior and interior packaging, Then check all the accessories are
included. If any parts are missing, please contact our customer service.
• Remove all the tapes on the unit. Open the transparent window, take out the
accessory parts inside.
• Clean the interior (such as water reservoir, Ice cube pushing spring etc.) with
lukewarm water and a soft cloth.
• Locating your ice maker on a level counter table far from direct sunlight and other
sources of heat (i.e.: stove, furnace, radiator). Maker sure that there is at least 15
centimeters between the back and sides of your ice maker with the wall.
• Allow one hour for the refrigerant fluid to settle down before plugging your ice
maker in.
• The power plug must be accessible directly.
Note: fill with potable water only. Only use drinking water!
Operation
1. Open the left side door, pour potable water into reservoir. Keep water level below
the "MAX" water level mark.
2. Plug your ice-maker into the main power outlet, then the
display window.
symbol will flash in LCD