Uline H-1024 Manuel page 7

PUSHER SPRING REPLACEMENT
1. Loosen the screws and nut with a 8mm spanner
wrench and a 4 mm Allen wrench. (See Figure 17)
2. Remove the magazine assembly. (See Figure 18)
3. Pull the pusher back until it stops on the rod, rotate
the pusher to position.
4. Push the magazine seat back and remove it from
the magazine.
Figure 17
PAGE 7 OF 21
TROUBLESHOOTING CONTINUED
Figure 18
Figure 20
1-800-295-5510
5. Loosen the screw and nut with a 2.5 mm Allen
wrench and 7mm socket wrench. (See Figure 19)
6. Loosen the rod with a 6mm offset wrench and
remove the pusher guides. Remove the pusher.
(See Figure 20)
7. Remove the spring pin with a hammer and 4 mm
straight rod. (See Figure 21)
Figure 19
Figure 21
uline.com
0421 IH-1024