Uline H-1024 Manuel page 5

Stop using the stapler immediately if any of the following problems occur.
Serious personal injury could occur. Any repairs or replacements must be
done by a qualified person or authorized service center only.
PROBLEM
Excessive jams
Uneven clinch
Unclinched staple
TEETH REPLACEMENT
1. Loosen screws and nut with an 8 mm wrench and
4 mm Allen wrench. (See Figure 10)
2. Remove the magazine assembly. (See Figure 11)
Figure 10
PAGE 5 OF 21
TROUBLESHOOTING
WARNING
CAUSE
Teeth screws are loose or
staples are wrong size.
Wrong staple size.
Teeth are loose or broken.
Figure 11
REMEDY
Tighten screws and check staples.
Check for proper leg length adjustment and
clincher size.
Check and replace teeth as needed.
3. Loosen screws with 3 mm Allen wrench.
(See Figure 12)
4. Change teeth one at a time to prevent reverse teeth.
Figure 12
0421 IH-1024