Uline H-1024 Manuel page 6

DRIVER REPLACEMENT
1. Loosen screw and nut with a 8 mm spanner wrench
and a 4 mm Allen wrench. (See Figure 13)
2. Remove the magazine assembly. (See Figure 14)
3. Loosen the set screw with a 3 mm Allen wrench to
unlock the adjusting rod. (See Figure 15)
4. Remove the linkage mechanism and adjusting rod
simultaneously from the body.
Figure 13
Figure 15
PAGE 6 OF 21
TROUBLESHOOTING CONTINUED
Figure 14
Figure 16
5. Loosen the pivot screws with flat screwdriver.
Remove handle and linkage mechanism.
6. Remove the spring pin with a hammer and 5 mm
straight rod.
7. Loosen screws with a 3 mm Allen wrench. Take off
the spring pin with a hammer and 6 mm straight rod.
(See Figure 16)
0421 IH-1024