Cycle Setting Buttons - LG DLEX2450 Série Mode D'emploi

Sécheuse de vapeur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CYCLE SETTING BUTTONS

SENSOR DRY cycles have preset settings
that are selected automatically. MANUAL DRY
cycles have default settings, but you may
customize the settings using the cycle setting
buttons. Press the button for that option to
view and select other settings.
NOTE: To protect your garments, not every
dryness level, temperature, or option is
available with every cycle. See the Cycle
Guide (page 29) for details.
DRY LEVEL
Selects the level of
dryness for the cycle.
Press the DRY LEVEL
button repeatedly to scroll
through available settings.
• This option is available only with SENSOR
DRY cycles.
• The dryer will automatically adjust the cycle
time. Selecting MORE DRY or VERY DRY
will increase the cycle time, while DAMP
DRY or LESS DRY will decrease the cycle
time.
• Use a DAMP DRY or LESS DRY setting for
items that you wish to iron.
TEMP. CONTROL
Adjusts the temperature
setting from ULTRA LOW
to HIGH. This allows
precise care of your
fabrics and garments.
Press the TEMP.
CONTROL button repeatedly to scroll through
available settings.
TIME DRY
Allows you to manually
select the drying time,
from 20 to 60 minutes,
in 10-minute increments.
Use this for small loads
or to remove wrinkles.
Use the MORE TIME/LESS TIME buttons to
add or reduce the drying time in 1-minute
increments.
Your dryer features several additional cycle
options to customize cycles to meet your
individual needs. Certain option buttons also
feature a special function (see the following page
for details) that can be activated by pressing and
holding that option button for 3 seconds.
To Add Cycle Options to a Cycle:
Turn on the dryer and turn the cycle selector
1
knob to select the desired cycle.
Use the cycle settings buttons to adjust the
2
settings for that cycle.
3
Press the cycle option button(s) for the
option you would like to add. A confirmation
message will be shown in the display.
4
Press the START/PAUSE button to start the
cycle. The dryer will start automatically.
WRINkLE CARE
Selecting this option will tumble
the load periodically for up to 3
hours after the selected cycle,
or until the door is opened.
This is helpful in preventing wrinkles when
you are unable to remove items from the dryer
immediately.
SIGNAL ON/OFF
To turn the SIGNAL off, press the
SIGNAL ON/OFF button. Press
again to turn the SIGNAL back on.
33

Publicité

Chapitres

Table des Matières
loading

Table des Matières