Electrical Connection - Hayward Easy Temp ECP 06 Manuel D'instructions Et D'installation

3. INSTALLATION AND CONNECTION (continued)

3.4 Electrical Connection

The electrical installation and wiring of this equipment must comply
with local installation standards.
F NF C15-100
D DIN VDE 0100-702
A ÖVE 8001-4-702
E UNE 20460-7-702 1993,
RECBT ITC-BT-31 2002
IRL Wiring Rules + IS HD 384-7-702
I CEI 64-8/7
LUX 384-7.702 S2
NL NEN 1010-7-702
P RSIUEE
Check that the available electrical power supply and the network
frequency correspond to the required operating current, taking into
account the appliance's specific location and the current needed to
power any other appliance connected to the same circuit.
ECP 06 230 V~ +/- 10 % 50 Hz 1 Phase
ECP 08 230 V~ +/- 10 % 50 Hz 1 Phase
ECP 11 230 V~ +/- 10 % 50 Hz 1 Phase
ECP 13 230 V~ +/- 10 % 50 Hz 1 Phase
ECP 15 230 V~ +/- 10 % 50 Hz 1 Phase
See the corresponding wiring diagram in the appendix.
The connection box is located on the right side of the unit. Three of the
connections are for the power supply and two are for the filtration pump
control (Servo control).
GB BS7671:1992
EW EVHS-HD 384-7-702
H MSZ 2364-702/1994/MSZ 10-553 1/1990
M MSA HD 384-7-702.S2
PL PN-IEC 60364-7-702:1999
CZ CSN 33 2000 7-702
SK STN 33 2000-7-702
SLO SIST HD 384-7-702.S2
TR TS IEC 60364-7-702
Power supply
Dry contact 7A Max
230V~ / 50Hz
potential free
7