Omcan CE-CN-CBR15 Manuel D'instructions page 13

Operation
OPERATION INSTRUCTIONS
OPERATION:
Turn the burners on about 15-20 minutes before cooking for preheating. Set the knobs to the desired flame
height or temperature. Each valve will control the gas flow to the burner to bring that area of the unit up to the
set temperature. If different temperature settings are to be used, adjoining areas should be set at progressively
higher temperatures using the lowest temperatures on the outside burners. A uniform and systematic approach
to the loading of the unit will produce the most consistent product results.
RADIANTS:
Place all the radiants in their position. Make sure that the radiants are setting properly into the slots on the front
and rear supports. Radiants should be centered over straight section of the burners.
Radiant Slot
COOKING GRATES:
Install the top cooking grates.
NOTE: When cooking grates are placed sloping toward the front, the grooves on top will guide the
excess fat drippings into the grease trough.
Grate Grate
13