Philips Sonicare FlexCare HX6982/10 Mode D'emploi page 8

EngliSh
8
personalizing your brushing experience
Sonicare automatically starts in the default Clean mode. To personalize
your brushing:
1 Prior to turning on the Sonicare, press the Personalized Brushing
button to toggle between modes and routines.
The green LED indicates selected mode or routine.
,
Note: When the toothbrush is turned on, you can switch between modes but
not between routines. Routines should be selected prior to brushing.
Brushing modes
Clean mode
Standard mode for superior teeth cleaning.
Sensitive mode
Gentle, yet thorough cleaning for sensitive gums and teeth.
Massage mode
Gentle gum stimulation.
Brushing routines
go Care routine
1-minute brushing cycle in the Clean mode, for a quick clean. You hear the
Quadpacer signal at 15-second intervals.
Max Care routine
3-minute brushing cycle that combines the Clean and Massage modes in
one routine for a thorough mouth clean. There are 30 seconds of Clean
mode and 15 seconds of Massage mode for each of the 4 sections of your
mouth. You will hear the Quadpacer signal at 45 second intervals.
Note: When Sonicare is used in clinical studies, the default 2-
minute Clean mode must be selected. The handle should be
fully charged. deactivate the Easy-start feature and for areas
where excess staining occurs, an additional 30 seconds of
brushing time can be spent to assist with stain removal.
Features
Easy-start
- This Sonicare model comes with the Easy-start feature activated.
- The Easy-start feature gently increases power over the first 14
brushings to ease into the Sonicare experience.
Note: Each of the first 14 brushings must be at least 1 minute in length to
properly move through the Easy-start ramp-up cycle.
deactivating or activating the Easy-start feature
1 Attach your brush head to the handle.
 Place the handle in the plugged-in charger.
- To deactivate Easy-start:
Press and hold the power button for 5 seconds. You hear 1 beep to
indicate that the Easy-start feature has been deactivated.