Installing And Removing The Batteries - Pioneer SGY-PM910H Mode D'emploi

Installing and Removing the Batteries

The batteries are pre-installed to this product. If the batteries are almost
empty (see page 16), replace the batteries with new ones.
• The product can be used as the ANT+ Power meter with the cyclocomputers of other
companies (power meter mode).
The product starts in pedaling monitor mode when the batteries are installed. To use
the product in power meter mode, switch the sensor mode (see page 10).
Replace the batteries of both the left and right sensors at the same time.
1.
Remove the cover.
• Be careful not to drop or lose the
battery when removing the cover.
•
Right transmitter (screws: 3 x)
Use a hex wrench (2 mm) to loosen
the screw and remove the cover.
• Be careful not to lose the removed
screw.
•
Left transmitter
Turn the cover to the left so the
triangular arrow points to [OPEN]
and remove it.
EN
7