Checking The Zero Point - Pioneer SGY-PM900H79 Mode D'emploi

Checking the Zero Point

1. Position the crank arm so it is
perpendicular to the ground.
2. Tap [Pedaling Monitor R] in
the sensor list screen of the
SGX-CA900.
3. Confirm the value in [Force
Preview].
Make sure that the [Tangential
Direction Force] and [Radial Direction
Force] values are as shown here.
• Tangential Direction Force: 0 ± 3 N
• Radial Direction Force: 0 ± 3 N
Calibrating the Sensors
Calibration of the right side is
finished. Calibrate the left side in the
same way.
Attach the pedal to the bicycle when
the left and right calibrations are
finished.
EN
13