Haverland AIRPURE 19 Mode D'emploi page 32

14
Put lter 1 (HEPA lter) back into the appliance.
Note: Make sure that the side with the tag is pointing towards you
Put lter 2 ( Activated Carbon lter) back into the appliance.
Note: Make sure that the side with the tag is pointing towards you.
Put lter 3 (Pre- lter) back into the appliance.
Note: Make sure that the side with the two tabs is pointing towards you.
Note: Make sure that all hooks are properly attached to the appliance.
To reattach the front panel, insert the bottom hooks into the
bottom of the appliance rst (1) . Then push the panel against the
body of the appliance (2).
Put the plug in the wall socket and switch on the appliance again.
Press the lter reset button with a thin tool.
Note : You do not need to press the lter reset button after cleaning
lter 1 (pre- lter).
Note : You cannot reset the appliance when you replace a lter before
its lter replacement light starts ashing.
Note: You cannot reset the appliance if it is not plugged in and
switched on.