Replacing The Lters - Haverland AIRPURE 19 Mode D'emploi

13
Healthy air protect lock.
If you do not replace the lter in time, the appliance stops operating in
approx. 2 weeks after the lter replacement light started ashing. When the
appliance is locked, it does not operate until you have replaced the new
lter and pressed the reset button.
Note: When lter replacement light 2 and REPLACE FILTER on the control
panel are on constantly, the appliance is locked ( see section "Filter
maintenance" in this chapter for more information).
How long it takes before the appliance is locked depend on the operating
time and speed level selected after the lter replacement alert.
Approximately 1 day before the appliance locks, the appliance will beep
every 30 minutes to inform you that one of the lters needs to be replaced .
You can switch o the appliance by pressing the on/o button.
If the appliance is locked:
Check which lter needs to be replaced ( see section "Filter
replacement lights").
Switch o the appliance and unplug it.
Replace the appropriate lter (see section "Replacing the lters")

Replacing the lters

Tip: Place the appliance against a wall for more stability when you
remove or insert the lters.
Switch o the appliance and unplug it.
Place your ngers in the recesses of the side panels and gently pull
the top part of the front panel towards you.Then lift the hooks at
the bottom of the panel out of the bottom of the appliance.
To remove lter 3 ( pre- lter), grab the two tabs and pull the lter
towards you.
To remove lter 2 (Activated Carbon lter) , grab its tag and pull it
towards you.
To remove lter 1 (HEPA lter) , grab its tag and pull it towards you.
Discard the lter that needs to be replaced and unpack the new
lter.