Koenic KMW 203 Mode D'emploi page 47

EN
OPERATION
Clock setting
Once the unit has been connected to the
power supply, the display shows '0:00' and an
acoustic signal is heard.
1. Press CLOCK/PRE-SET once. The hour
digits start flashing in the display.
2. Turn the rotary control to set the correct
hour value.
3. Press CLOCK/PRE-SET. The minute digits
start flashing.
4. Turn the rotary control to set the correct
minutes.
5. Press CLOCK/PRE-SET to finish setting the
time. The symbol ': 'flashes and the correct
time is shown.
6. The time setting process can be cancelled
by pressing STOP/CLEAR.
Note
The clock must be set when the appliance
is connected for the first time, and also if a
power failure has re-set the clock.
46