LaserLiner CAT III Mode D'emploi page 15

• When connecting to a voltage, always connect the black
measuring lead first before the red lead. Follow the reverse
procedure when disconnecting.
• Only the original measuring leads may be used. Their voltage,
category and ampere rated powers must match those of the
measuring device.
Additional information on use
Observe the technical safety regulations for working on electrical
systems, especially: 1. Safely isolating from power supply,
2. Securing to prevent system being switched on again,
3. Checking zero potential, two-pole, 4. Earthing and short-
circuiting, 5. Securing and covering adjacent live components.
Safety instructions
Dealing with electromagnetic radiation
• The measuring device complies with electromagnetic compatibility
regulations and limit values in accordance with EMC-Directive
2014/30/EU.
• Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards or
interference or be subject to hazards or interference.
3
red
5
black
1
1 Rotary switch to set the
measuring function
2 Red input socket (+)
2
3 Black COM socket (–)
4
4 Red 10 A input socket (+)
5 LCD
6 Test prods
7 Measuring contacts:
red "+", black "–"
MultiMeter
6
EN
7
15