Fault Indications And Rectification Of Faults - CASO DESIGN Sound & Cool Mode D'emploi Original

15.6 Fault indications and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Device does not operate.
Your device is not cold enough or it
does not reach the adjusted
temperature. Compressor does not
stop to work.
Vibrations.
The device seems to make to
much noise
The door will not close properly.
Control panel does not show
anything..
Buttons do not work.
Compressor will not start
Dew on the surface of device：
Liquid sound
Condensation formed inside the
cabinet
Attention
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Possible Cause
Not plugged in using different voltage. The circuit
breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed
completely. The door seal does not seal properly.
The device does not have the correct clearance.
Device is over filled.
Check to assure that the device is level.
The device is not level.
- Components are loose - Device touches the wall
The device is not level.
The seal is weak. Device is over filled.
Electronic defect. Contact the customer service.
Control panel is damaged.
Room temperature is lower than desired
temperature.
The surface of wine cabinet especially the door
appear some frost if item in a damp room. This is
due to the moisture in the air coming into contact
with the device. Please wipe it away with dry cloth.
The sound of compressor when starts or stops
working. The flowing sound of refrigerant in the
refrigeration system. The evaporating sound of
refrigerant in the evaporator
Under the environment with high level of humidity
or the drawer has been left open for a long period
or opened frequently, wipe off the drawer and walls
and close the drawer as long as possible.
47