Overview And Site Preparation; Step A - Install Supply Water Fitting; Step C - Install Reverse Osmosis Filter Assembly - AEG RO Manuel D'installation Et D'utilisation

Overview and Site Preparation

OVERVIEW
Read through the entire manual before beginning your installation.
There are seven steps to installing your Drinking Water system.
They are as follows:
STEP A - Install Cold Water Supply fitting
STEP B - Install Drain Adapter
STEP C - Install Reverse Osmosis Assembly
STEP D - Install Storage Tank
STEP E - Install Reverse Osmosis Faucet
STEP F - Connect Tubing
STEP G - Sanitize, Pressure Test, Purge System
These steps are explained in detail over the next few pages. Follow
all steps. Reading this manual will also help you receive and use all
the benefits your Reverse Osmosis system can give you.
PREPARE SITE FOR INSTALLATION
1. Before starting, close the hot and cold water shutoff valves (See
Figure 5).
2. Temporarily place tank and filter assembly into planned location.
Check position of items and space required for proper installation.
Ensure tubes may be routed without kinking.
3. Remove tank and filter from planned location and set aside.
NOTE: You must check and comply with all local plumbing
codes.
NOTE: For best system performance, the feed water to the
system should be softened or have hardness less than 1.7
mol/m3 (17°f), with no iron.
54

Step A - Install Supply Water Fitting

Check and comply with national and local
plumbing codes as you plan, then install a
supply (cold) water fitting. The fitting must
provide a leak tight connection to the RO 1/4»
(6.35 mm) OD tubing, see Figure 20, page 13.
A typical installation, using standard plumbing
fittings is shown in Figure 5.
IMPORTANT: Before starting, close the
hot and cold water shutoff valves (See
Figure 5). Use a pan to catch water when
disassembling the pipe.
Complying with plumbing codes, install a fitting
on the cold water pipe to adapt 1/4» (6.35
mm) OD tubing. A typical connection is shown
in Figure 5. You can use solder or threaded
fittings. If threaded fittings are used, be sure
FIG. 4
to use pipe joint compound or Teflon tape on
outside threads.
Do not connect the tubing to the fitting at this
time.
This will occur later in the installation (page 13).
WATER SUPPLY TYPICAL CONNECTION
(using included fitting)
Hot Water
Shutoff Valve
Cold Water
Shutoff Valve
feed water supply
fitting (included)
1/4" green tubing
to RO inlet
cold water
pipe
55
FIG. 5