Dometic GROUP WAECO CoolMatic HDC-150 Instructions De Montage Et De Service page 34

_HDC150.book Seite 34 Donnerstag, 9. Dezember 2010 8:19 20
Installing the refrigerator
6.2 Installing the refrigerator
NOTE
I
The installation dimensions can be found in fig. 9, page 7.
➤ Install the refrigerator as shown in fig. 9, page 7 to fig. 0, page 8.
➤ Fix the cover panel to the refrigerator door as shown in fig. a, page 8 to
fig. b, page 9.
6.3 Connecting the refrigerator to the power supply
Connecting to a battery
NOTICE!
A
To avoid voltage drops and loss of performance, keep the con-
nection cable as short as possible and not be interrupted.
For this reason avoid additional switches, plugs or multi-way
adapters.
Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick charg-
ing device.
Overvoltage can damage the electronics of the device.
The refrigerator can be operated with a 12 volt to 24 volt DC voltage supply.
For safety reasons, the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against re-
versed polarity when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage
is insufficient (see table below).
Cut-off voltage
Cut-in voltage
34
12 V 24 V
10.4 V 22.8 V
11.7 V 24.2 V
HDC-150