Selecting A Display Language; Registering The Handset For The First Time - Auerswald COMfortel M-520 Notice D'utilisation

The rechargeable battery is fully charged when the lighting flash symbol
goes out in the display.
Caution: The handset must be charged in the charging cradle supplied
with it!
Note: The rechargeable battery might warm up during charging. This is
not dangerous. For technical reasons, the charging capacity of the
rechargeable battery reduces over time.

Selecting a Display Language

The language setting display is displayed. The set
language (e. g. English) is marked (
1. Press until the required language, e.g. Français,
is marked in the display.
2. Press the right-hand key directly under the display to activate the language.
3. Exiting the menu: Press
If you need to display the menu again, do this:
1. Press the middle of the control key
2. Slowly press

Registering the Handset for the First Time

These instructions describe how to register the telephone on a COMfortel WS-
500S or COMfortel WS-500M base station for the first time.
Requirements:
• The handset has been configured in the base station
• Registration has been triggered in the base station.
Note: You can configure the base station manually or by provisioning via
the PBX. Please refer to the base station Operation Guide for instructions.
Note: You can find out the handset's IPUI in the battery compartment and
on the packaging label or scan it in. Alternatively, you can view the IPUI
on the display. To do so, press the centre of the control key
the menu, In it, enter *#06#. The first entry you see is the IPUI. Example:
1: 029E74A560
When you first commission the handset, the message Please register
handset is displayed when you select the language.
• Press Register to confirm the message Please register handset on the
handset.
COMfortel M-520 - Instructions V03 02/2020
for a long time.
and , one after the other.
Initial Commissioning
Deutsch
= selected).
English
Français
.
to display
29