Archos VR Manuel D'utilisation page 18

Functions Introduction
Two Take Off Methods
1. Method 1 (Take off) : After successful frequency
pairing, move the Left and Right levers at the same
time as shown Picture 5 (inward 45 degree) to start
the motors. Push up the Left lever to fly the drone to
a certain altitude and then release the lever.
2. Method 2 (One Button Take Off): Press the Take Off
/ Landing / Emergency Stop Button (Picture 9) , the
drone flies up automatically and keep flying at an
altitude of approximately 1.2 meters.
Take off/Landing/Emergency stop button
Landing Methods
1. Method 1 (Landing): Push the Left lever all the way
down to the lowest position(Picture 2/6) and hold
it till the motors stop and the drone will land on the
ground.
2. Method 2 (One Button Landing): Press the Take
Off / Landing / Emergency Stop Button once
shortly(picture 9), and the drone will land on the
ground automatically.
(When using this function, you can not touch the left
lever, if not, then the function will fail)
Picture 9
18