Archos VR Manuel D'utilisation page 14

1. Turn on the drone and put it on a flat surface in a
horizontal position. The drone's body lights change
from flashing to solid bright, which indicates
successful frequency pairing.
2. Do not move the left lever
before successful calibration.
Push the right lever as
Picture 8 shown and then
release. The drone's body
lights flash, which indicates that the drone is
calibrating. When the drone's body lights become
solid, the calibration is complete.
Notice: If the drone crashes, the gyroscope can be
affected causing flight issues. If so, turn the power
off and on again to calibrate.
Flying Control
Notice: Every time before the drone takes off, move the
left lever and right lever at the same time as shown on
Picture 5(inward 45 degree) to start the motors. Push
up the left lever slowly to fly the drone or press down
the one button take off .
14