Uniks R18 Mode D'emploi page 3

AC voltage detector and cyclic sense
Of the phases without contact
r18
1. WARNINGS
Respect the safety rules indicated in the user manual.
• Read understand and follow safety rules and operating instructions in the manual
before using this tester.
•The tester's safety features may not protect the user if not used in accordance with
the manufacturer's instructions.
•Check on a known live source within the rated AC voltage range of the tester before
use to ensure it is in working order.
•Insulation type and thickness, distance from the voltage source, shielded wires, and
other factors may effect reliable operation. Use other methods to verify live voltage,
if there is any uncertainty.
•Do not use if the tester appears damaged or if it is not operating properly. If in doubt,
replace the tester.
•Do not use on voltages that are higher than as marked on the tester.
•Use caution with voltages above 30 volts AC as a shock hazard may exist.
•Comply with all applicable safety codes. Use approved
personal protective equipment when working near live electrical circuits-particularly
with regard to arc-flash potential.
•Do not operate tester if Low Battery warning occurs. Replace batteries immediately.
2. International security symbols
potential danger. Indicates that the user should
refer to the Manual for important safety
information
Indicates dangerous voltages may be present
The equipment is protected by double or reinforced
insulation
dsadasdsdad
3. General Specifications
100V to 1000VAC
Detection Voltage Range
200V to 1000V
Phase Voltage Range
50/60Hz
Frequency Range
Two AAA 1.5V batteries
Batteries
Operating Temperature 0 to 50°C (32 to 122°F)
-10 to 60°C (14 to 140°F)
Storage Temperature
80% max.
Humidity
Altitude 2000 meters
2
Pollution Degree
CAT IV 1000V
Safety Compliance
IP67
IP Rating
4. Description Detector
1. Battery cover
2. Flashlight
6
3. Flashlight button
4.Phases Cyclic Sense button
5. 0n / 0ff button 7
6. LED indicators
7.Punta Detector
8.Worklight
5. Operations
5-1.Turning the Tester On
Press the tester ON/OFF Button, the tester will beep once and the green LED and worklighit
will illuminate to indicate that the tester is working on high voltage mode and ready for use.
5-2.Turning the Tester Off
Press the ON/OFF Button one more time, the tester will beep twice and range LED will turn
off.
5-3.Mode Select Function
• When the tester is on with NCV function, short press the
flash slowly alternately to indicate that the tester is working on phase sequence test mode.
• Short press Button again, the yellow led off and the green LED illuminate, the tester returns
to high voltage mode.
• The tester will beep once every Button operation
• The Button operation is valid only when the NCV function is turned on
once, the green and yellow LED
.