Picking Up Spills; Lubrication - Uline HOOVER COMMERCIAL STEAMVAC H-3482 Mode D'emploi

PICKING UP SPIllS

The Hoover SteamVac spotter/carpet cleaner may be
used to pick up small liquid spills (1 gallon or less, never
to exceed 1/4 inch in depth) on carpet.
1. Place floor nozzle with brushes turned to Spill Pick
Up in front of the spill. Pull the nozzle very slowly
over the spill initially with suction only. Repeat with
spray and suction. Although no cleaning solution
can completely remove all spots, they can be
treated by following the instructions provided by the
manufacturer of the carpet being cleaned.
WArNING! Do not use the cleaner to pick up
flammable or combustible liquids
or chemicals.
2. When finished cleaning, follow "After Cleaning"
instructions. (See Page 6)
STORAGE
Before storing:
• Empty solution tank and rinse thoroughly with clean
water.
OPERATING ISSUE
Cleaner won't run
Suction is low
Clean solution won't
dispense
Brushes/brush indicator
won't rotate
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 7 OF 14
HOW TO USE CONTINUED
TROUblEShOOTING
rECOMMENDATIONS
1. Power cord not firmly plugged into outlet.
2. No voltage in plug.
3. Blown fuse or tripped breaker.
1. Recovery tank lid not on correctly.
2. Recovery tank full/automatic shut-off
engaged.
1. Solution tank not firmly in place.
2. Solution tank is empty.
3. Recovery tank lid not on correctly.
1. Indicator screen is dirty.
2. Speed selector is on Spill Pick Up.
1-800-295-5510
uline.com
• Replace empty solution tank and turn cleaner ON.
Squeeze trigger and push cleaner forward and
back several times to expel any solution remaining
in the cleaner's system. (Do not use cleaner on
wood floors.)
• Empty recovery tank and rinse thoroughly with clean
water.
• Allow brushes and underside of cleaner to air dry
thoroughly before storing cleaner on a carpeted or
wood surface.
NOTE: Do not store cleaner with a full solution
tank in place.

lUbRICATION

The motor is equipped with bearings that contain
sufficient lubrication for the life of the motor. The
addition of lubricant could cause damage. Therefore,
do not add lubricant to motor bearings. The agitator
brushroll is equipped with two ball bearings that should
be lubricated periodically.
POSSIblE SOlUTION
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Check fuse/breaker in home. Replace fuse/
reset breaker.
1. Make sure lid is on securely.
2. Remove and empty recovery tank.
1. Make sure tank is securely locked in
position.
2. Refill tank according to instructions for
surface being cleaned.
3. Make sure lid is firmly in place.
1. Remove clear cover over indicator and
clean screen. Replace cover.
2. Move speed selector to Gentle Scrub or
Power Scrub.
0713 IH-3482