Velleman CAMSET12 Mode D'emploi page 2

3. Operation
a) Properly connect the audio/video cable to either the AV1 or the AV2 input (see wiring diagram).
b) Plug the 12V DC power source into the DC jack.
c) Turn the main power on and put the power switch to "ON".
d) Press "mode" to select volume
e) Press ◄ or ►to adjust from 0 to 100 (mirror ON/OFF)
f) To reset all settings: switch off the LCD monitor (main power must be off), press "mode" and ◄ at the same time.
Switch the power to ON (main power switch) again and press "mode" to access the factory settings, avoid making
any adjustments and switch the power OFF and ON again. The monitor has now been reset to its original factory
settings.
g) Auto power off: the monitor will automatically turn off when the video signal is lost for more than 3 minutes, push
"power" to turn on the monitor.
h) The monitor is in standby mode when the power switch is off, please shut down the main power or disconnect the
power cable when the device is not in use.
4. Wiring Diagram = Bedrading = Câblage
Note that the 12VDC adapter is optional and that you can never use AV2 and the camera connection at the
same time.
CAMSET12_v2
brightness contrast
2
colour tint (NTSC only) mute mirror.
VELLEMAN