Personalising The Daily Program - ABB Elos Série Mode D'emploi

P E R S O N A L I S I N G T H E D A I LY P R O G R A M
Press the SET/PROG key twice to personalise the preset daily program or modify it.
USER INSTRUCTIONS
The message "PROG" is displayed on the VDU, while the
bar of the first day of the week starts to blink. Select the
required day using the
Press the MODE key within 30 seconds to confirm the
selection.
After confirmation of the day, the current profile, relative
to the day selected, is displayed on the VDU.
The time will start to blink. Use the
ment the time until the time for modifying the proposed
profile is reached: the column relative to the time select-
ed will blink during the increment of the time profile.
Press the MODE key within 30 seconds to confirm the
selection.
One of the symbols,
and the value corresponding to the selected set point is
displayed.
The keys are then used to select the new set
point, which will be applied up to the next variation pre-
sent in the program.
Pressing the MODE key again makes it possible to select
another time, starting from which a new set point can be
selected in the way just described.
35
keys.
keys to incre-
, or will blink on the VDU
E
N
G
L
I
S
H